Intermec CN2B Uživatelský manuál stáhnout pdf (Strana 23)

Chapter 1 — Using the CN2B Computer

CN2B Mobile Computer User’s Manual 5

3 Connect the AC power supply to the power connector on the back of the

CN2B Communications Dock, and then connect the power cord to the

AC power supply.

You must use only the Intermec power supply approved for use with

the CN2B Computer. Using any other power supply will damage the

CN2B Computer.

Note: For help installing and using the communications dock, see the CN2

Communications Dock Quick Start Guide (P/N: 930-061-001), which

shipped with the dock.

4 Connect the power cord to an AC power outlet. The green Power light

on the CN2B Communications Dock turns on.

AC power

supply

Communications

dock

Power

light

CN2

5 Place the CN2B Computer in the communications dock. The battery is

fully charged in approximately four hours.

Removing the Battery

Follow these instructions to remove the battery from the CN2B Computer.

Only use either the stylus or the bottom tabs on the battery door to dis-

lodge and remove the battery. Using any other tool or method to

remove the battery may damage the battery or the CN2B Computer.

Removing the main battery when the backup battery low or critically

low icon appears on the status bar may cause your CN2B Computer to

cold boot and you may lose data.

If you fail to replace the battery immediately, you may lose important

data or applications.

1 2 ... 18 19 20 21 22 23 24 25 26 27 28 ... 263 264

Žádné komentáře

Intermec CN2B Uživatelský manuál Strana 23