Intermec PB50 Uživatelský manuál stáhnout pdf (Strana 25)

Chapter 1 — Using the PB50 Mobile Label and Receipt Printer

PB50 Mobile Label and Receipt Printer User’s Guide 15

7 Press and hold the Feed button for more than two seconds to

calibrate the media.

Printing a Testprint

After you have loaded media in the printer, you are ready to print a

testprint. You can choose from several testprint options for each type

of firmware. If you cannot get the testprint information to print, see

“Troubleshooting the PB50” on page 42.

To print a testprint with a PB50 loaded with IPL firmware

1 Press the Setup button.

2 Press until you reach Test/Service.

3 Press to enter the Test/Service menu system.

4 Press to enter the Testprint Config menu.

5 Press to enter the Config menu.

6 Press to choose a testprint.

7 Press to print the Config testprint of your choice.

To print a testprint with a PB50 loaded with Fingerprint firmware

1 Press the Setup button.

2 Press until you reach Print Defs.

3 Press to enter the Print Defs menu system.

4 Press until you reach Testprint.

5 Press to enter the Testprint menu.

6 Press to choose a testprint.

7 Press to print the testprint of your choice.

Before you can print a self test with ESC/P firmware, you need to

establish communications between the PB50 and your network. For

help, see

“Establishing Communications With a Host” on page 27.

To print a self test with a PB50 loaded with ESC/P firmware

• Send the ESC EZ{TP} command to the printer.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 71 72

Žádné komentáře

Intermec PB50 Uživatelský manuál Strana 25