Intermec EASYCODER PD4 Uživatelský manuál stáhnout pdf (Strana 71)

Intermec EasyCoder PD4—User’s Guide 61

Chapter 9—Adjustments

5 Turn both screws at the front of the printhead carefully clockwise a

quarter of a turn at a time (a full turn corresponds to 0.5 mm which

is a lot). Make sure to make identical adjustments on both the screws!

If you get lost, tighten both screws by turning them counterclockwise

as far as they go and start all over again.

6 Engage the printhead and Lock the printhead by tightening the two

screws at the top of the printhead bracket, that is, the reverse action of

step #3.

7 Load the ribbon (only in case of thermal transfer printing).

8 Test and readjust if necessary. (Hint! If you use direct thermal media

you will not have to load and remove the ribbon over and over again.)

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 99 100

Žádné komentáře

Intermec EASYCODER PD4 Uživatelský manuál Strana 71