Intermec PC43t Uživatelský manuál stáhnout pdf (Strana 56)

Chapter 2 — Set Up the Printer

42 PC23 and PC43 Desktop Printer User Manual

About Cut-Off Printing

In cut-off printing, each label is automatically cut from the media roll

immediately after the label is printed. You can print on non-adhesive,

continuous label stock. You can also use self-adhesive labels with a

liner, but you must cut only the liner.

The cutter module includes the top of form sensor. You can also install

the optional cutter tray accessory, which holds up to 20 labels or

tickets.

After you load media, you need to configure the cutter and the feed

adjust settings. You may need to adjust the recommended values

slightly depending on your media type, supply method, and roll sizes,

or because of individual differences between printers.

Caution: You must not use the cutter to cut through any kind of

adhesive, or other soft material, that may stick to the cutting parts

and render the cutter inoperable or even damage the electric

motor.

Note: Feed adjust values for simulator command languages like

ESim, ZSim, and DSim are preset.

Recommended Feed Adjust Values for Cut-Off Printing

Printer Setting 203 dpi 300 dpi Distance

PC43d Start Adjust -294 -434 -36.80 mm (-1.45 in)

Stop Adjust 170 251 21.3 mm (0.84 in)

PC43t Start Adjust -372 -550 -46.60 mm (-1.45 in)

Stop Adjust 264 389 33 mm (0.84 in)

1 2 ... 51 52 53 54 55 56 57 58 59 60 61 ... 189 190

Žádné komentáře

Intermec PC43t Uživatelský manuál Strana 56