Intermec 6620 Uživatelský manuál stáhnout pdf (Strana 121)

SECTION 8 CMOS Setup

6620 Hand-Held Computer Technical Reference 8-7

" COM Port:

Sets one of the following addresses or disables

the primary COM port:

" COM1, 3F8, IRQ 4 (default)

" COM3, 338, IRQ 4

" COM3, 3E8, IRQ 4

" COM3, 2E8, IRQ 4

" COM3, 220, IRQ 4

" Disabled

" 5 Volt Power:

Enabled, this provides 5 volts power out of pin 9

of the primary COM port. Typically used for

tethered scanners — ON or OFF (default).

NOTE: The IR Port and the Ext COM Port cannot share COM2.

" IR Port:

Sets the COM1, 2F8, IRQ 10 address (default); or

disables the IR Port.

" Ext COM Port:

Sets either the COM2, 2F8, IRQ 3 or COM4,

2E8, IRQ 3 address; or disables the external

COM port (default).

" Scanner Port:

(Read-Only) Displays the address for the inter-

nal scanner port.

" Aux Port:

Sets the 308, IRQ 5 address; or disables the Aux-

iliary port (default). In the 6620 Computer, this

port is attached to the optional internal GPS ra-

dio module. (See Section 4 about the GPS driv-

ers.)

" IR Type:

Sets the IrDA type — IrDA1.0 (default), IrDA1.1,

or ASK.

1 2 ... 116 117 118 119 120 121 122 123 124 125 126 ... 145 146

Žádné komentáře

Intermec 6620 Uživatelský manuál Strana 121